KD200 Acrylic Acid Powder Coating

Introduction:
Using hydroxy polyester resin, fillers and pigments and auxiliary agent as raw materials
Application Fields:
Suitable for all kinds of exterior metallic products: agriculture machines, automobile parts, courtyard fence, fitness equipment, industrial equipment, exterior lights, exterior air-conditioning and architecture material etc. More
Characteristics: 
Good leveling, abrasion resistance and chemicals resistance property. Excellent adhesion between the coatings and substrate. Good mechanical property and it isn't easy to turn yellow when baking. 
Features:
S.G.:  1.2-1.7［g/cm3］ (Varies with colour and gloss)
Particle Size: Varies with different purposes, the average particle size is generally 35-40 µm
Storage: The products must be stored in a dry room with temperature below 30℃ and avoid direct sunlight. Under this condition, powder coatings could be stored safely for 12 months. Expired product couldn't be used until test result meets the utilization standards.
Utilization Rate: 8-12㎡/kg, film thickness is 70 µm (100% utilization rate). Practical coating zone varies with shapes of coating equipments and objects.
Transportation: The product is not dangerous, and can be transported in any means. However, avoid contamination from  direct sunlight exposure, water, oil and other chemical pollution.
Film Effects:
There are many surface effects for this product. Customers can chose different special surface effects with entire gloss range from high to low: winkle, sand and metallic effects etc. (Please refer to our colour card). Customization service is available in accordance with customer's requirement. (Special effects included).
Film Properties:

Notification is required when there is a need to have the coating film more than 120μm thick while ordering to avoid unnecessary pin-holes or affect the saturation of the film.
Spray Guide：This product is suitable for following coating methods according to the customers' requirements: corona electrostatic spraying, friction electrostatic spraying, electrostatic fluidized beds spraying and fluidized beds dipping.

Film Thickness:Range 40—80µm
Surface Treatment of Substrates: Choose a proper way in accordance with different metallic materials. （Please ask our company for more information, if needed）
Maintenance:
Please clean up the surface regularly, frequency of cleaning should be more at areas which are very salty and seriously contaminated.
1、Wipe the surface with wet cotton cloth to avoid scratches.
2、Add some detergent into warm water, and then wipe the dust, salt and other stain on the surface of film with cotton cloth which has dipped the detergent above.
3、Wipe out the residual detergent when cleaning.
Hygienic and Safety:
There are neither toxic ingredients in the all the raw materials of powder coating, nor toxic gas releasing when baking. However, the inhalation of dust during use should be avoided. An operator should wear PPE such as dust respirator, eyeglasses and protective clothing etc., and try best to avoid long- time contact with the power coatings. The coatings stick to skin could be washed away by soap. Please give a prior notice if the coating is used in toys to make sure that there is no metallic material to harm the health of children.