HOTLINE:400-968-9677    中文版    English

·
Powder coating

KD300 Polyurethane Powder Coating

 

Hotline:0536-8673066
Details

Introduction:
Using high quality carboxyl resin and hydroxyl alkyl amide (HAA) curing agent as major raw material, which has good climate resistance and salt spray resistance properties.
Application Fields:
Suitable for any of exterior metallic products: agricultural equipments, car parts, courtyard fence, fitness equipments, exterior lights, exterior air-conditionings and architecture materials etc.
Characteristics:
Excellent adhesion between coating and substrate. Good mechanical, heat-resistance and chemicals-resistance properties. The film also has fire-retardant and extinguishing property to some extent. This product is safer, more environmental, and healthier than TGIC type. There will be pinholes if the thickness of the film is more than 100 μm. 
Features:
S.G.: 1.2-1.7[g/cm3] (Varies with colour and gloss)
Particle Size: varies with different purposes, the average particle size is generally 35-40 µm
Storage: The products must be stored in a dry room with temperature below 30℃, and avoid direct sunlight. Under this condition, powder coatings could be stored safely for 12 months. Expired product couldn't be used until test result meets the utilization standards.
Utilization Rate: 8-12㎡/kg, film thickness is 70 µm (100% utilization rate). Practical coating zone varies with shapes of coating equipments and objects.
Transportation: The product is not dangerous, and can be transported in any means. However, avoid contamination from direct sunlight exposure, water, oil and other chemical pollution.

There are many surface effects for this product. Customers can chose different special surface effects with entire gloss range from high to low: winkle, sand and metallic effects etc. (Please refer to our colour card). Customization service is available in accordance with customer's requirement. (Special effects included).

Film Properties:

Notification is required when there is a need to have the coating film more than 120μm thick while ordering to avoid unnecessary pin-holes or affect the saturation of the film.
Spray Guide:
This product is suitable for following coating methods according to the customers' requirements: corona electrostatic spraying, friction electrostatic spraying, electrostatic fluidized beds spraying and fluidized beds dipping.

 

 Curing Conditions
 Temperature of Object(℃)
 Time(Minutes)
 Curing Conditions Recommendations
 180
 15
 May Be Designed Accordingto Requirements
 200
 10
 
 160
 20

Film Thickness:Range 40—80µm
Surface Treatment of Substrates:
Choose a proper way in accordance with different metallic materials. (Please ask us for more information, if needed)

Maintenance:
Please clean up the surface regularly, and clean more at areas which are very salty and seriously contaminated.
1、Wipe the surface with wet cotton cloth to avoid scratches.
2、Add some detergent into warm water, and then wipe the dust, salt and other stain on the surface of film with cotton cloth which has dipped the detergent above.
3、Wipe out the residual detergent when cleaning.

Hygienice and Safety:
There are neither toxic ingredients in the all the raw materials of powder coating, nor toxic gas releasing when baking. However, the inhalation of dust during use should be avoided. An operator should wear PPE such as dust respirator, eyeglasses and protective clothing etc., and try best to avoid long- time contact with the power coatings. The coatings stick to skin could be washed away by soap. Please give a prior notice if the coating is used in toys to make sure that there is no metallic material to harm the health of children.